DS black acrylic camera kit
New version! laser cut black acrylic plate, protected by a plastic sheet on each side.
Assembly kit for the detention center cameras, version with a 8mm thick black acrylic plate, idealized in material and strength but accurate in thickness and color. You just need to get 6 viewers and put everything together!
The kits have been created after a careful study of the movie stills as well as photos of real found parts. A precise 3D model was then created to determine the most exact possible measurements.
What is included in the kit :
- 8mm black acrylic plate, protected by a plastic sheet on each side (plate is drilled for 100x100mm VESA mounts. The mounts holes are now doubled to choose between centered or a bit offseted to the top of the plate as seen in the movie.)
- two already assembled aluminium antennas, no assembly or glue required here except for the thin antenna
- 2 M5 screws to attach the antennas to the plates
- 24 screws to attach the viewers
- red round stickers (16mm)
- white round stickers (13mm)
- a piece of blue painter tape to match some of the screen-used cameras
- 6 gloss black cardboard backed rectangles to put inside the viewers and darken the lenses
- small template to position the holes on the viewers
- 4 M4 screws, nuts and washers to possibly attach to the mount. They must be put on the plate before mounting the viewers as you won't have access anymore afterwards.
- 24 small plastic washers to compensate for the back curvature of the viewers
NEW: now comes with 6 white rectangle stickers to put on the Patersons, not shown on the photos.
An assembly guide can be found on the RPF message board here:
https://www.therpf.com/forums/threads/death-star-detention-center-camera-kits-...